P0708 Transmission Range Sensor A Circuit High
What it means
The gear-position sensor signal is higher than it should be, often from an open wire, a bad connection or a failed sensor.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check that the shifter lines up with the gear shown on the dash
- Inspect the range sensor connector for water, corrosion or damage
- Check the range sensor readings with a scanner while moving through each gear
Signs you may notice
- Check engine light on
- Engine may not start in Park or Neutral, or may start in gear
- Gear indicator on the dash may be wrong or blank
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty transmission range sensor (neutral safety switch)
- CommonRange sensor out of adjustment
- CommonDamaged wiring or corroded connector at the sensor
- PossibleWorn or misadjusted shift cable or linkage
Typical repair once the cause is confirmed
Usually adjusting or replacing the transmission range sensor, or repairing its wiring or the shift linkage.
Common questions
What does P0708 mean?
The gear-position sensor signal is higher than it should be, often from an open wire, a bad connection or a failed sensor.
Can I drive with code P0708?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0708?
Common possibilities to test include: faulty transmission range sensor (neutral safety switch); range sensor out of adjustment; damaged wiring or corroded connector at the sensor; worn or misadjusted shift cable or linkage. A shop should confirm the cause before replacing parts.