Home › Code lookup › P0707
Powertrain code · Transmission

P0707 Transmission Range Sensor A Circuit Low

How urgent? Get it checked in the next few days

What it means

The gear-position sensor signal is lower than it should be, which usually points to a short to ground or a bad sensor.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check that the shifter lines up with the gear shown on the dash
  2. Inspect the range sensor connector for water, corrosion or damage
  3. Check the range sensor readings with a scanner while moving through each gear

Signs you may notice

  • Check engine light on
  • Engine may not start in Park or Neutral, or may start in gear
  • Gear indicator on the dash may be wrong or blank

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty transmission range sensor (neutral safety switch)
  • CommonRange sensor out of adjustment
  • CommonDamaged wiring or corroded connector at the sensor
  • PossibleWorn or misadjusted shift cable or linkage

Typical repair once the cause is confirmed

Usually adjusting or replacing the transmission range sensor, or repairing its wiring or the shift linkage.

Repair costInsufficient verified pricing for this vehicle and repair
Replace transmission range sensor. Prepare an itemized shop request.
Walk through it step by step: Car won't start →

Common questions

What does P0707 mean?

The gear-position sensor signal is lower than it should be, which usually points to a short to ground or a bad sensor.

Can I drive with code P0707?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0707?

Common possibilities to test include: faulty transmission range sensor (neutral safety switch); range sensor out of adjustment; damaged wiring or corroded connector at the sensor; worn or misadjusted shift cable or linkage. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.