Home › Code lookup › P070F
Powertrain code · Transmission

P070F Transmission Fluid Level Too Low

How urgent? Get it checked in the next few days

What it means

The computer thinks there isn't enough fluid in the transmission. Driving low on fluid can quickly damage the transmission.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the fluid level the way the maker specifies (many need the engine running and fluid at a set temperature)
  2. Look for leaks at the pan, lines, cooler and seals

Signs you may notice

  • Check engine or transmission light on
  • Slipping or delayed shifts
  • Fluid spots under the car

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonTransmission fluid leak
  • CommonFluid not refilled correctly after a service
  • PossibleFaulty fluid level sensor or wiring

Typical repair once the cause is confirmed

Fix any leak and fill to the correct level with the right fluid; replace the level sensor only if the fluid level is actually correct.

Walk through it step by step: Transmission fluid leak →

Common questions

What does P070F mean?

The computer thinks there isn't enough fluid in the transmission. Driving low on fluid can quickly damage the transmission.

Can I drive with code P070F?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P070F?

Common possibilities to test include: transmission fluid leak; fluid not refilled correctly after a service; faulty fluid level sensor or wiring. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.