Home › Code lookup › P0716
Powertrain code · Transmission

P0716 Input/Turbine Speed Sensor A Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The input shaft speed signal doesn't match what the computer expects for the engine and road speed.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector and wiring for damage or oil
  2. Check fluid level and condition
  3. Watch input speed on a scanner while driving to see if the signal drops out

Signs you may notice

  • Check engine light on
  • Harsh, late or erratic shifts
  • Transmission stuck in one gear (limp mode)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty input/turbine speed sensor
  • CommonDamaged wiring or connector to the sensor
  • PossibleLow or dirty transmission fluid

Typical repair once the cause is confirmed

Most often a new input speed sensor or a wiring repair; on some models the sensor is inside the transmission.

Repair costInsufficient verified pricing for this vehicle and repair
Replace input/turbine speed sensor. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0716 mean?

The input shaft speed signal doesn't match what the computer expects for the engine and road speed.

Can I drive with code P0716?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0716?

Common possibilities to test include: faulty input/turbine speed sensor; damaged wiring or connector to the sensor; low or dirty transmission fluid. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.