Home › Code lookup › P0717
Powertrain code · Transmission

P0717 Input/Turbine Speed Sensor A Circuit No Signal

How urgent? Get it checked in the next few days

What it means

The computer isn't getting any signal at all from the transmission's input shaft speed sensor.

Can I keep driving?

With no input speed signal the transmission often goes into limp mode and stays in one gear. Drive slowly and only as needed to reach a shop soon. Avoid highways, and stop driving if it slips, flares in RPM or a transmission warning appears.

What to test before replacing parts

Check the sensor's power, ground and signal wiring for an open circuit, pull the sensor to look for metal debris, and confirm the signal is truly missing before replacing it.

  1. Inspect the sensor connector and wiring for damage or oil
  2. Check fluid level and condition
  3. Watch input speed on a scanner while driving to see if the signal drops out

Signs you may notice

  • Check engine light on
  • Harsh, late or erratic shifts
  • Transmission stuck in one gear (limp mode)
  • Speedometer may act up on some models

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty input/turbine speed sensor
  • CommonDamaged wiring or connector to the sensor
  • PossibleLow or dirty transmission fluid
  • PossibleMetal debris on the sensor tip
  • PossibleTransmission computer fault

Typical repair once the cause is confirmed

Most often a new input speed sensor or a wiring repair; on some models the sensor is inside the transmission.

Repair costInsufficient verified pricing for this vehicle and repair
Replace input/turbine speed sensor. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0717 mean?

The computer isn't getting any signal at all from the transmission's input shaft speed sensor.

Can I drive with code P0717?

With no input speed signal the transmission often goes into limp mode and stays in one gear. Drive slowly and only as needed to reach a shop soon. Avoid highways, and stop driving if it slips, flares in RPM or a transmission warning appears.

What causes P0717?

Common possibilities to test include: faulty input/turbine speed sensor; damaged wiring or connector to the sensor; low or dirty transmission fluid; metal debris on the sensor tip. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.