P0718 Input/Turbine Speed Sensor A Circuit Intermittent
What it means
The input shaft speed signal keeps dropping in and out, often from a loose connector or chafed wire.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the sensor connector and wiring for damage or oil
- Check fluid level and condition
- Watch input speed on a scanner while driving to see if the signal drops out
Signs you may notice
- Check engine light on
- Harsh, late or erratic shifts
- Transmission stuck in one gear (limp mode)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty input/turbine speed sensor
- CommonDamaged wiring or connector to the sensor
- PossibleLow or dirty transmission fluid
Typical repair once the cause is confirmed
Most often a new input speed sensor or a wiring repair; on some models the sensor is inside the transmission.
Common questions
What does P0718 mean?
The input shaft speed signal keeps dropping in and out, often from a loose connector or chafed wire.
Can I drive with code P0718?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0718?
Common possibilities to test include: faulty input/turbine speed sensor; damaged wiring or connector to the sensor; low or dirty transmission fluid. A shop should confirm the cause before replacing parts.