Home › Code lookup › P0720
Powertrain code · Transmission

P0720 Output Shaft Speed Sensor Circuit

How urgent? Get it checked in the next few days

What it means

The computer isn't getting a good signal from the sensor that measures how fast the transmission's output shaft (and so the wheels) is turning.

Can I keep driving?

Usually drivable with care to a shop soon, but the speedometer may be wrong, so watch your speed, and shifting or traction control may act up. If it gets stuck in one gear, slips, or brake warning lights come on, keep trips short and gentle or have it towed.

What to test before replacing parts

Check whether the speedometer works, inspect the sensor wiring and connector, and pull the sensor to check for metal debris or a damaged tone ring before replacing it.

  1. Check whether the speedometer works
  2. Inspect the sensor connector and wiring
  3. Pull the sensor and check its tip for metal debris

Signs you may notice

  • Check engine light on
  • Speedometer may stop working or jump around
  • Harsh or erratic shifts, or limp mode
  • ABS or traction control light may come on in some vehicles

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty output shaft speed sensor
  • CommonDamaged wiring or connector to the sensor
  • PossibleMetal debris on the sensor tip
  • PossibleDamaged reluctor (tone) ring
  • PossibleTransmission computer fault

Typical repair once the cause is confirmed

Most often a new output speed sensor or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace output shaft speed sensor. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Transmission warning light on →

Common questions

What does P0720 mean?

The computer isn't getting a good signal from the sensor that measures how fast the transmission's output shaft (and so the wheels) is turning.

Can I drive with code P0720?

Usually drivable with care to a shop soon, but the speedometer may be wrong, so watch your speed, and shifting or traction control may act up. If it gets stuck in one gear, slips, or brake warning lights come on, keep trips short and gentle or have it towed.

What causes P0720?

Common possibilities to test include: faulty output shaft speed sensor; damaged wiring or connector to the sensor; metal debris on the sensor tip; damaged reluctor (tone) ring. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.