Home › Code lookup › P0722
Powertrain code · Transmission

P0722 Output Shaft Speed Sensor Circuit No Signal

How urgent? Get it checked in the next few days

What it means

The computer isn't getting any signal from the transmission's output shaft speed sensor.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check whether the speedometer works
  2. Inspect the sensor connector and wiring
  3. Pull the sensor and check its tip for metal debris

Signs you may notice

  • Check engine light on
  • Speedometer may stop working or jump around
  • Harsh or erratic shifts, or limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty output shaft speed sensor
  • CommonDamaged wiring or connector to the sensor
  • PossibleMetal debris on the sensor tip

Typical repair once the cause is confirmed

Most often a new output speed sensor or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace output shaft speed sensor. Prepare an itemized shop request.
Walk through it step by step: Transmission warning light on →

Common questions

What does P0722 mean?

The computer isn't getting any signal from the transmission's output shaft speed sensor.

Can I drive with code P0722?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0722?

Common possibilities to test include: faulty output shaft speed sensor; damaged wiring or connector to the sensor; metal debris on the sensor tip. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.