P0724 Torque Converter/Brake Switch B Circuit High
What it means
There's a problem with the brake pedal switch signal the transmission uses to know when you're braking. The signal is higher than expected, often meaning the computer thinks the brake is always pressed.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Have someone confirm the brake lights come on and go off with the pedal
- Check the brake light fuse
- Inspect and test the brake pedal switch and its connector
Signs you may notice
- Check engine light on
- Brake lights may stay on or not work
- Torque converter may not unlock when stopping, causing a stall or shudder
- Cruise control may not work
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty or misadjusted brake pedal switch
- CommonBlown fuse for the brake light circuit
- PossibleDamaged wiring or connector at the brake switch
- PossibleBurned-out brake bulbs on some models
Typical repair once the cause is confirmed
Most often a new or readjusted brake pedal switch, or repair of a fuse or wiring fault in that circuit.
Common questions
What does P0724 mean?
There's a problem with the brake pedal switch signal the transmission uses to know when you're braking. The signal is higher than expected, often meaning the computer thinks the brake is always pressed.
Can I drive with code P0724?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0724?
Common possibilities to test include: faulty or misadjusted brake pedal switch; blown fuse for the brake light circuit; damaged wiring or connector at the brake switch; burned-out brake bulbs on some models. A shop should confirm the cause before replacing parts.