Home › Code lookup › P0726
Powertrain code · Transmission

P0726 Engine Speed Input Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The engine speed signal the transmission computer receives doesn't make sense compared with other readings.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for crankshaft sensor or network codes and fix those first
  2. Inspect the wiring and connectors between the computers

Signs you may notice

  • Check engine light on
  • Harsh or erratic shifting
  • Tachometer may act up
  • Engine may stall or not start if the crankshaft signal is lost

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty crankshaft position sensor
  • CommonDamaged wiring between the engine and transmission computers
  • PossibleNetwork or computer communication fault

Typical repair once the cause is confirmed

Usually a crankshaft position sensor or a wiring repair, depending on where the signal is lost.

Walk through it step by step: Harsh or late shifting →

Common questions

What does P0726 mean?

The engine speed signal the transmission computer receives doesn't make sense compared with other readings.

Can I drive with code P0726?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0726?

Common possibilities to test include: faulty crankshaft position sensor; damaged wiring between the engine and transmission computers; network or computer communication fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.