Home › Code lookup › P072D
Powertrain code · Transmission

P072D Stuck in Gear 2

How urgent? Get it checked in the next few days

What it means

The computer has found the transmission stuck in gear 2 and not shifting out of it the way it should.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the fluid level and condition
  2. Read all transmission codes and check solenoid operation with a scanner
  3. Make sure the shift cable and range sensor are adjusted correctly

Signs you may notice

  • Check engine or transmission warning light on
  • Transmission will not shift out of (or into) the gear named in the code
  • Car may be stuck in limp mode or unable to move

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty shift solenoid or valve body
  • CommonLow fluid or low line pressure
  • PossibleWorn or damaged clutch inside the transmission
  • PossibleShift cable or range sensor fault

Typical repair once the cause is confirmed

Depends on the cause: fluid correction, solenoid or valve body repair, or internal transmission repair.

Walk through it step by step: Transmission warning light on →

Common questions

What does P072D mean?

The computer has found the transmission stuck in gear 2 and not shifting out of it the way it should.

Can I drive with code P072D?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P072D?

Common possibilities to test include: faulty shift solenoid or valve body; low fluid or low line pressure; worn or damaged clutch inside the transmission; shift cable or range sensor fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.