P0743 Torque Converter Clutch Solenoid Circuit Electrical
What it means
The computer found an electrical fault (open or shorted wiring) in the torque converter clutch solenoid circuit.
Can I keep driving?
Usually drivable to a shop in the next few days, with higher highway RPM and worse fuel economy. If the engine stalls when you come to a stop, the car shudders hard, or the transmission slips, keep driving to a minimum and get it checked right away.
What to test before replacing parts
Measure the solenoid's resistance and check the circuit for opens or shorts through the transmission connector and internal harness before replacing the solenoid or computer.
- Check fluid level and condition
- Check the solenoid resistance and wiring through the transmission connector
- Watch converter slip on a scanner at steady highway speed
Signs you may notice
- Check engine light on
- Worse fuel economy
- Higher RPM than normal at highway speed
- Shudder at 30 to 50 mph or stalling when coming to a stop
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty torque converter clutch solenoid
- CommonDamaged wiring or connector (often the internal harness)
- CommonLow or burnt transmission fluid
- PossibleWorn torque converter
- PossibleFaulty brake switch signal
Typical repair once the cause is confirmed
Most often a new torque converter clutch solenoid or a wiring repair; a worn converter needs the transmission removed.
Common questions
What does P0743 mean?
The computer found an electrical fault (open or shorted wiring) in the torque converter clutch solenoid circuit.
Can I drive with code P0743?
Usually drivable to a shop in the next few days, with higher highway RPM and worse fuel economy. If the engine stalls when you come to a stop, the car shudders hard, or the transmission slips, keep driving to a minimum and get it checked right away.
What causes P0743?
Common possibilities to test include: faulty torque converter clutch solenoid; damaged wiring or connector (often the internal harness); low or burnt transmission fluid; worn torque converter. A shop should confirm the cause before replacing parts.