Home › Code lookup › P0744
Powertrain code · Transmission

P0744 Torque Converter Clutch Solenoid Circuit Intermittent

How urgent? Get it checked in the next few days

What it means

The torque converter clutch solenoid circuit is cutting in and out, so lockup may come and go.

Can I keep driving?

Usually drivable with care, but lockup may come and go, causing shudder or surging. If the engine stalls when you stop, the car bucks hard or a transmission warning appears, limit driving and get it checked promptly.

What to test before replacing parts

Wiggle-test the connector and harness while watching the solenoid circuit on a scanner, check for corrosion or fluid in the connector, and confirm the dropout before replacing parts.

  1. Check fluid level and condition
  2. Check the solenoid resistance and wiring through the transmission connector
  3. Watch converter slip on a scanner at steady highway speed

Signs you may notice

  • Check engine light on
  • Worse fuel economy
  • Higher RPM than normal at highway speed
  • Shudder at 30 to 50 mph or stalling when coming to a stop

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty torque converter clutch solenoid
  • CommonDamaged wiring or connector (often the internal harness)
  • CommonLow or burnt transmission fluid
  • PossibleWorn torque converter
  • PossibleFaulty brake switch signal

Typical repair once the cause is confirmed

Most often a new torque converter clutch solenoid or a wiring repair; a worn converter needs the transmission removed.

Repair costInsufficient verified pricing for this vehicle and repair
Replace torque converter clutch solenoid. Prepare an itemized shop request.
Walk through it step by step: Gas mileage suddenly worse →

Common questions

What does P0744 mean?

The torque converter clutch solenoid circuit is cutting in and out, so lockup may come and go.

Can I drive with code P0744?

Usually drivable with care, but lockup may come and go, causing shudder or surging. If the engine stalls when you stop, the car bucks hard or a transmission warning appears, limit driving and get it checked promptly.

What causes P0744?

Common possibilities to test include: faulty torque converter clutch solenoid; damaged wiring or connector (often the internal harness); low or burnt transmission fluid; worn torque converter. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.