Home › Code lookup › P0770
Powertrain code · Transmission

P0770 Shift Solenoid E

How urgent? Get it checked in the next few days

What it means

There's a problem with shift solenoid E, one of the electric valves the computer uses to change gears.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check fluid level and condition
  2. Measure the solenoid resistance through the transmission connector
  3. Command the solenoid on and off with a scanner and watch for a gear change

Signs you may notice

  • Check engine light on
  • Transmission stuck in one gear or skipping gears
  • Harsh, late or erratic shifts

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty shift solenoid
  • CommonDamaged wiring or connector (often the internal harness)
  • CommonLow or dirty transmission fluid

Typical repair once the cause is confirmed

Usually a new shift solenoid (on many models sold as a solenoid pack) or a wiring repair; check the fluid first.

Repair costInsufficient verified pricing for this vehicle and repair
Replace shift solenoid E. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0770 mean?

There's a problem with shift solenoid E, one of the electric valves the computer uses to change gears.

Can I drive with code P0770?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0770?

Common possibilities to test include: faulty shift solenoid; damaged wiring or connector (often the internal harness); low or dirty transmission fluid. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.