Home › Code lookup › P078C
Powertrain code · Transmission

P078C Shift/Timing Solenoid B Low

How urgent? Get it checked in the next few days

What it means

The circuit for shift timing solenoid B reads lower than normal, often from a short to ground.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check fluid level and condition
  2. Measure the solenoid resistance through the transmission connector

Signs you may notice

  • Check engine light on
  • Harsh or badly timed shifts
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty shift timing solenoid
  • CommonDamaged wiring or connector (often the internal harness)
  • PossibleLow or dirty transmission fluid

Typical repair once the cause is confirmed

Usually a new shift timing solenoid or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace shift timing solenoid. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P078C mean?

The circuit for shift timing solenoid B reads lower than normal, often from a short to ground.

Can I drive with code P078C?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P078C?

Common possibilities to test include: faulty shift timing solenoid; damaged wiring or connector (often the internal harness); low or dirty transmission fluid. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.