P078E Shift/Timing Solenoid B Intermittent
What it means
The circuit for shift timing solenoid B is cutting in and out.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check fluid level and condition
- Measure the solenoid resistance through the transmission connector
Signs you may notice
- Check engine light on
- Harsh or badly timed shifts
- Transmission may go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty shift timing solenoid
- CommonDamaged wiring or connector (often the internal harness)
- PossibleLow or dirty transmission fluid
Typical repair once the cause is confirmed
Usually a new shift timing solenoid or a wiring repair.
Common questions
What does P078E mean?
The circuit for shift timing solenoid B is cutting in and out.
Can I drive with code P078E?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P078E?
Common possibilities to test include: faulty shift timing solenoid; damaged wiring or connector (often the internal harness); low or dirty transmission fluid. A shop should confirm the cause before replacing parts.