Home › Code lookup › P0791
Powertrain code · Transmission

P0791 Intermediate Shaft Speed Sensor A Circuit

How urgent? Get it checked in the next few days

What it means

The computer isn't getting a good signal from the sensor that measures the speed of a shaft in the middle of the transmission.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector and wiring
  2. Watch the intermediate speed reading on a scanner while driving

Signs you may notice

  • Check engine light on
  • Harsh or erratic shifts
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty intermediate shaft speed sensor
  • CommonDamaged wiring or connector to the sensor
  • PossibleMetal debris on the sensor tip

Typical repair once the cause is confirmed

Usually a new intermediate shaft speed sensor or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace intermediate shaft speed sensor. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0791 mean?

The computer isn't getting a good signal from the sensor that measures the speed of a shaft in the middle of the transmission.

Can I drive with code P0791?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0791?

Common possibilities to test include: faulty intermediate shaft speed sensor; damaged wiring or connector to the sensor; metal debris on the sensor tip. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.