Home › Code lookup › P0798
Powertrain code · Transmission

P0798 Pressure Control Solenoid C Electrical

How urgent? Get it checked in the next few days

What it means

The computer found an open or shorted circuit in the wiring for the third pressure control solenoid.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check fluid level and condition
  2. Measure the solenoid resistance through the transmission connector

Signs you may notice

  • Check engine light on
  • Harsh or very soft shifts
  • Slipping or delayed engagement

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty pressure control solenoid
  • CommonDamaged wiring or connector (often the internal harness)
  • CommonLow or dirty transmission fluid
  • PossibleSticking valve in the valve body

Typical repair once the cause is confirmed

Usually a new pressure control solenoid (on some models part of the solenoid pack or valve body) or a wiring repair; check the fluid first.

Repair costInsufficient verified pricing for this vehicle and repair
Replace pressure control solenoid C. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0798 mean?

The computer found an open or shorted circuit in the wiring for the third pressure control solenoid.

Can I drive with code P0798?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0798?

Common possibilities to test include: faulty pressure control solenoid; damaged wiring or connector (often the internal harness); low or dirty transmission fluid; sticking valve in the valve body. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.