Home › Code lookup › P0804
Powertrain code · Transmission

P0804 1-4 Upshift (Skip Shift) Lamp Control Circuit

How urgent? Book a check when convenient

What it means

The dash light that tells you the car will shift from 1st straight to 4th has an electrical problem in its control circuit.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check whether the skip shift light works during the bulb check at start-up
  2. Check the lamp circuit wiring for an open or short

Signs you may notice

  • Check engine light on
  • Skip shift light on the dash may not work or stay on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonBurned-out bulb or failed instrument cluster indicator
  • CommonDamaged wiring or connector
  • PossibleFaulty engine computer (rare)

Typical repair once the cause is confirmed

Repair the lamp circuit wiring or the indicator in the instrument cluster.

Where it shows up

  • Known on manual-transmission Chevrolet Corvette and Camaro models with the 1-to-4 skip shift feature

Common questions

What does P0804 mean?

The dash light that tells you the car will shift from 1st straight to 4th has an electrical problem in its control circuit.

Can I drive with code P0804?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0804?

Common possibilities to test include: burned-out bulb or failed instrument cluster indicator; damaged wiring or connector; faulty engine computer (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.