P0805 Clutch Position Sensor Circuit
What it means
The computer found an electrical problem in the circuit for the clutch position sensor, which tells the computer how far the clutch pedal is pressed, or how far an automated clutch is engaged.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the wiring and connector at the clutch position sensor for damage, rubbing or corrosion
- Check related fuses, power and ground with a meter
- Test the clutch position sensor against the factory specification before replacing it
Signs you may notice
- Check engine light on
- Engine may not crank, or cruise control may not work
- Jerky clutch engagement on automated manual transmissions
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed clutch position sensor
- CommonBroken or damaged wiring to the clutch position sensor
- CommonLoose, corroded or water-damaged connector
- PossibleBlown fuse or missing power or ground
- PossibleFaulty transmission or engine computer (rare)
Typical repair once the cause is confirmed
Repair any wiring or connector fault found; if the circuit tests good, replace the clutch position sensor.
Common questions
What does P0805 mean?
The computer found an electrical problem in the circuit for the clutch position sensor, which tells the computer how far the clutch pedal is pressed, or how far an automated clutch is engaged.
Can I drive with code P0805?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0805?
Common possibilities to test include: failed clutch position sensor; broken or damaged wiring to the clutch position sensor; loose, corroded or water-damaged connector; blown fuse or missing power or ground. A shop should confirm the cause before replacing parts.