P0807 Clutch Position Sensor Circuit Low
What it means
The computer sees a signal or voltage in the clutch position sensor circuit that is lower than it should be. The clutch position sensor tells the computer how far the clutch pedal is pressed, or how far an automated clutch is engaged.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the clutch position sensor wiring for chafed spots touching metal
- Check the circuit for a short to ground with a meter
- Unplug the clutch position sensor and see whether the reading changes
Signs you may notice
- Check engine light on
- Engine may not crank, or cruise control may not work
- Jerky clutch engagement on automated manual transmissions
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWire shorted to ground in the clutch position sensor circuit
- CommonFailed clutch position sensor (internal short)
- PossibleCorroded or water-damaged connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Fix any shorted or damaged wiring; if the wiring is good, replace the clutch position sensor.
Common questions
What does P0807 mean?
The computer sees a signal or voltage in the clutch position sensor circuit that is lower than it should be. The clutch position sensor tells the computer how far the clutch pedal is pressed, or how far an automated clutch is engaged.
Can I drive with code P0807?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0807?
Common possibilities to test include: wire shorted to ground in the clutch position sensor circuit; failed clutch position sensor (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.