Home › Code lookup › P0810
Powertrain code · Transmission

P0810 Clutch Position Control Error

How urgent? Get it checked in the next few days

What it means

The computer is commanding the automated clutch to a position, but the clutch is not getting there as expected.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for other clutch or actuator codes
  2. Run the clutch adaptation relearn with a scan tool
  3. Check hydraulic fluid level if the system uses one

Signs you may notice

  • Transmission warning or check engine light on
  • Jerky take-off or clutch slipping
  • Car may not move or may refuse a gear

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn clutch or clutch needing a relearn
  • CommonFaulty clutch actuator
  • PossibleLow hydraulic fluid or hydraulic leak
  • PossibleClutch position sensor problem

Typical repair once the cause is confirmed

Relearn the clutch first; if the fault returns, repair the actuator or replace the worn clutch.

Walk through it step by step: Clutch slipping →

Common questions

What does P0810 mean?

The computer is commanding the automated clutch to a position, but the clutch is not getting there as expected.

Can I drive with code P0810?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0810?

Common possibilities to test include: worn clutch or clutch needing a relearn; faulty clutch actuator; low hydraulic fluid or hydraulic leak; clutch position sensor problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.