Home › Code lookup › P0906
Powertrain code · Transmission

P0906 Gate Select Position Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the gate select position sensor circuit that is lower than it should be. The gate select sensor tells an automated manual transmission which shift gate (side-to-side position) its shift mechanism is in.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the gate select sensor wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the gate select sensor and see whether the reading changes

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWire shorted to ground in the gate select sensor circuit
  • CommonFailed gate select position sensor (internal short)
  • PossibleCorroded or water-damaged connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the gate select sensor.

Common questions

What does P0906 mean?

The computer sees a signal or voltage in the gate select position sensor circuit that is lower than it should be. The gate select sensor tells an automated manual transmission which shift gate (side-to-side position) its shift mechanism is in.

Can I drive with code P0906?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0906?

Common possibilities to test include: wire shorted to ground in the gate select sensor circuit; failed gate select position sensor (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.