P0900 Clutch Actuator Circuit/Open
What it means
The computer found an electrical problem in the circuit for the clutch actuator, which engages and releases the clutch automatically on automated manual and dual-clutch transmissions.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the wiring and connector at the clutch actuator for damage, rubbing or corrosion
- Check related fuses, power and ground with a meter
- Test the clutch actuator against the factory specification before replacing it
Signs you may notice
- Transmission warning or check engine light on
- Jerky take-off or slipping clutch
- Car may not move or may refuse to shift
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed clutch actuator
- CommonBroken or damaged wiring to the clutch actuator
- CommonLoose, corroded or water-damaged connector
- PossibleBlown fuse or missing power or ground
- PossibleFaulty transmission or engine computer (rare)
Typical repair once the cause is confirmed
Repair any wiring or connector fault found; if the circuit tests good, replace the clutch actuator.
Common questions
What does P0900 mean?
The computer found an electrical problem in the circuit for the clutch actuator, which engages and releases the clutch automatically on automated manual and dual-clutch transmissions.
Can I drive with code P0900?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0900?
Common possibilities to test include: failed clutch actuator; broken or damaged wiring to the clutch actuator; loose, corroded or water-damaged connector; blown fuse or missing power or ground. A shop should confirm the cause before replacing parts.