Home › Code lookup › P0912
Powertrain code · Transmission

P0912 Gate Select Actuator Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the gate select actuator circuit that is lower than it should be. The gate select actuator moves the shift mechanism side to side between gates on an automated manual transmission.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the gate select actuator wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the gate select actuator and see whether the reading changes

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWire shorted to ground in the gate select actuator circuit
  • CommonFailed gate select actuator (internal short)
  • PossibleCorroded or water-damaged connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the gate select actuator.

Repair costInsufficient verified pricing for this vehicle and repair
Replace gate select actuator. Prepare an itemized shop request.

Common questions

What does P0912 mean?

The computer sees a signal or voltage in the gate select actuator circuit that is lower than it should be. The gate select actuator moves the shift mechanism side to side between gates on an automated manual transmission.

Can I drive with code P0912?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0912?

Common possibilities to test include: wire shorted to ground in the gate select actuator circuit; failed gate select actuator (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.