Home › Code lookup › P0902
Powertrain code · Transmission

P0902 Clutch Actuator Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the clutch actuator circuit that is lower than it should be. The clutch actuator engages and releases the clutch automatically on automated manual and dual-clutch transmissions.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the clutch actuator wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the clutch actuator and see whether the reading changes

Signs you may notice

  • Transmission warning or check engine light on
  • Jerky take-off or slipping clutch
  • Car may not move or may refuse to shift

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWire shorted to ground in the clutch actuator circuit
  • CommonFailed clutch actuator (internal short)
  • PossibleCorroded or water-damaged connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the clutch actuator.

Repair costInsufficient verified pricing for this vehicle and repair
Replace clutch actuator. Prepare an itemized shop request.
Walk through it step by step: Clutch slipping →

Common questions

What does P0902 mean?

The computer sees a signal or voltage in the clutch actuator circuit that is lower than it should be. The clutch actuator engages and releases the clutch automatically on automated manual and dual-clutch transmissions.

Can I drive with code P0902?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0902?

Common possibilities to test include: wire shorted to ground in the clutch actuator circuit; failed clutch actuator (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.