P0901 Clutch Actuator Circuit Range/Performance
What it means
The clutch actuator is giving readings that don't match what the computer expects for the current conditions. The clutch actuator engages and releases the clutch automatically on automated manual and dual-clutch transmissions.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Compare the clutch actuator reading with what it should be on a scan tool
- Inspect the wiring and connector for corrosion or damage
Signs you may notice
- Transmission warning or check engine light on
- Jerky take-off or slipping clutch
- Car may not move or may refuse to shift
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing clutch actuator
- PossibleWorn clutch or clutch needing a relearn
- PossibleHigh resistance in the wiring or connector
- PossibleControl module software needs an update
Typical repair once the cause is confirmed
Correct any fluid or wiring problem first; if the readings are still wrong, replace the clutch actuator.
Common questions
What does P0901 mean?
The clutch actuator is giving readings that don't match what the computer expects for the current conditions. The clutch actuator engages and releases the clutch automatically on automated manual and dual-clutch transmissions.
Can I drive with code P0901?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0901?
Common possibilities to test include: failing clutch actuator; worn clutch or clutch needing a relearn; high resistance in the wiring or connector; control module software needs an update. A shop should confirm the cause before replacing parts.