Home › Code lookup › P0909
Powertrain code · Transmission

P0909 Gate Select Control Error

How urgent? Get it checked in the next few days

What it means

On an automated manual transmission, the computer commanded the shift mechanism to move to a gate (side-to-side position), but it did not get there.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Scan for actuator and sensor codes
  2. Run the shift system relearn with a scan tool

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty gate select actuator
  • CommonBinding or worn shift mechanism
  • PossibleGate select position sensor problem
  • PossibleLow hydraulic pressure on hydraulic systems

Typical repair once the cause is confirmed

Relearn the system; if it returns, repair the actuator or binding shift mechanism.

Common questions

What does P0909 mean?

On an automated manual transmission, the computer commanded the shift mechanism to move to a gate (side-to-side position), but it did not get there.

Can I drive with code P0909?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0909?

Common possibilities to test include: faulty gate select actuator; binding or worn shift mechanism; gate select position sensor problem; low hydraulic pressure on hydraulic systems. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.