Home › Code lookup › P0911
Powertrain code · Transmission

P0911 Gate Select Actuator Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The gate select actuator is giving readings that don't match what the computer expects for the current conditions. The gate select actuator moves the shift mechanism side to side between gates on an automated manual transmission.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Compare the gate select actuator reading with what it should be on a scan tool
  2. Inspect the wiring and connector for corrosion or damage

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing gate select actuator
  • PossibleBinding shift mechanism inside the gearbox
  • PossibleHigh resistance in the wiring or connector
  • PossibleControl module software needs an update

Typical repair once the cause is confirmed

Correct any fluid or wiring problem first; if the readings are still wrong, replace the gate select actuator.

Repair costInsufficient verified pricing for this vehicle and repair
Replace gate select actuator. Prepare an itemized shop request.

Common questions

What does P0911 mean?

The gate select actuator is giving readings that don't match what the computer expects for the current conditions. The gate select actuator moves the shift mechanism side to side between gates on an automated manual transmission.

Can I drive with code P0911?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0911?

Common possibilities to test include: failing gate select actuator; binding shift mechanism inside the gearbox; high resistance in the wiring or connector; control module software needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.