P0907 Gate Select Position Circuit High
What it means
The computer sees a signal or voltage in the gate select position sensor circuit that is higher than it should be. The gate select sensor tells an automated manual transmission which shift gate (side-to-side position) its shift mechanism is in.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the gate select sensor circuit for an open wire or a short to voltage
- Test the gate select sensor against the factory specification
Signs you may notice
- Transmission warning or check engine light on
- Gears may be refused, slow or harsh to engage
- Transmission may go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the gate select sensor circuit
- CommonFailed gate select position sensor
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the gate select sensor.
Common questions
What does P0907 mean?
The computer sees a signal or voltage in the gate select position sensor circuit that is higher than it should be. The gate select sensor tells an automated manual transmission which shift gate (side-to-side position) its shift mechanism is in.
Can I drive with code P0907?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0907?
Common possibilities to test include: open or broken wire in the gate select sensor circuit; failed gate select position sensor; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.