P0910 Gate Select Actuator Circuit/Open
What it means
The computer found an electrical problem in the circuit for the gate select actuator, which moves the shift mechanism side to side between gates on an automated manual transmission.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the wiring and connector at the gate select actuator for damage, rubbing or corrosion
- Check related fuses, power and ground with a meter
- Test the gate select actuator against the factory specification before replacing it
Signs you may notice
- Transmission warning or check engine light on
- Gears may be refused, slow or harsh to engage
- Transmission may go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed gate select actuator
- CommonBroken or damaged wiring to the gate select actuator
- CommonLoose, corroded or water-damaged connector
- PossibleBlown fuse or missing power or ground
- PossibleFaulty transmission or engine computer (rare)
Typical repair once the cause is confirmed
Repair any wiring or connector fault found; if the circuit tests good, replace the gate select actuator.
Common questions
What does P0910 mean?
The computer found an electrical problem in the circuit for the gate select actuator, which moves the shift mechanism side to side between gates on an automated manual transmission.
Can I drive with code P0910?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0910?
Common possibilities to test include: failed gate select actuator; broken or damaged wiring to the gate select actuator; loose, corroded or water-damaged connector; blown fuse or missing power or ground. A shop should confirm the cause before replacing parts.