P0925 Gear Shift Reverse Actuator Circuit Range/Performance
What it means
The gear shift reverse actuator is giving readings that don't match what the computer expects for the current conditions. The reverse shift actuator pulls the shift mechanism rearward into gear on an automated manual transmission.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Compare the reverse shift actuator reading with what it should be on a scan tool
- Inspect the wiring and connector for corrosion or damage
Signs you may notice
- Transmission warning or check engine light on
- Gears may be refused, slow or harsh to engage
- Transmission may go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing gear shift reverse actuator
- PossibleBinding shift mechanism inside the gearbox
- PossibleHigh resistance in the wiring or connector
- PossibleControl module software needs an update
Typical repair once the cause is confirmed
Correct any fluid or wiring problem first; if the readings are still wrong, replace the reverse shift actuator.
Common questions
What does P0925 mean?
The gear shift reverse actuator is giving readings that don't match what the computer expects for the current conditions. The reverse shift actuator pulls the shift mechanism rearward into gear on an automated manual transmission.
Can I drive with code P0925?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0925?
Common possibilities to test include: failing gear shift reverse actuator; binding shift mechanism inside the gearbox; high resistance in the wiring or connector; control module software needs an update. A shop should confirm the cause before replacing parts.