P0926 Gear Shift Reverse Actuator Circuit Low
What it means
The computer sees a signal or voltage in the gear shift reverse actuator circuit that is lower than it should be. The reverse shift actuator pulls the shift mechanism rearward into gear on an automated manual transmission.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the reverse shift actuator wiring for chafed spots touching metal
- Check the circuit for a short to ground with a meter
- Unplug the reverse shift actuator and see whether the reading changes
Signs you may notice
- Transmission warning or check engine light on
- Gears may be refused, slow or harsh to engage
- Transmission may go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWire shorted to ground in the reverse shift actuator circuit
- CommonFailed gear shift reverse actuator (internal short)
- PossibleCorroded or water-damaged connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Fix any shorted or damaged wiring; if the wiring is good, replace the reverse shift actuator.
Common questions
What does P0926 mean?
The computer sees a signal or voltage in the gear shift reverse actuator circuit that is lower than it should be. The reverse shift actuator pulls the shift mechanism rearward into gear on an automated manual transmission.
Can I drive with code P0926?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0926?
Common possibilities to test include: wire shorted to ground in the reverse shift actuator circuit; failed gear shift reverse actuator (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.