P0928 Gear Shift Lock Solenoid Control Circuit/Open
What it means
The computer found an electrical problem in the circuit for the shift lock solenoid, which keeps the shifter locked in Park until you press the brake pedal.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the wiring and connector at the shift lock solenoid for damage, rubbing or corrosion
- Check related fuses, power and ground with a meter
- Test the shift lock solenoid against the factory specification before replacing it
Signs you may notice
- Shifter may be stuck in Park
- Or the shifter may leave Park without the brake pressed
- Check engine light on
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed shift lock solenoid
- CommonBad brake light switch
- CommonBroken or damaged wiring to the shift lock solenoid
- CommonLoose, corroded or water-damaged connector
- PossibleBlown fuse or missing power or ground
- PossibleFaulty transmission or engine computer (rare)
Typical repair once the cause is confirmed
Repair any wiring or connector fault found; if the circuit tests good, replace the shift lock solenoid.
Common questions
What does P0928 mean?
The computer found an electrical problem in the circuit for the shift lock solenoid, which keeps the shifter locked in Park until you press the brake pedal.
Can I drive with code P0928?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0928?
Common possibilities to test include: failed shift lock solenoid; bad brake light switch; broken or damaged wiring to the shift lock solenoid; loose, corroded or water-damaged connector. A shop should confirm the cause before replacing parts.