Home › Code lookup › P0931
Powertrain code · Transmission

P0931 Gear Shift Lock Solenoid Control Circuit High

How urgent? Book a check when convenient

What it means

The computer sees a signal or voltage in the shift lock solenoid circuit that is higher than it should be. The shift lock solenoid keeps the shifter locked in Park until you press the brake pedal.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the connector for pushed-out or loose pins
  2. Check the shift lock solenoid circuit for an open wire or a short to voltage
  3. Test the shift lock solenoid against the factory specification

Signs you may notice

  • Shifter may be stuck in Park
  • Or the shifter may leave Park without the brake pressed
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken wire in the shift lock solenoid circuit
  • CommonBad brake light switch
  • CommonFailed shift lock solenoid
  • PossibleWire shorted to another power circuit
  • PossiblePoor ground or loose connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Repair the open or shorted wire or bad connector; if the wiring is good, replace the shift lock solenoid.

Repair costInsufficient verified pricing for this vehicle and repair
Replace shift lock solenoid. Prepare an itemized shop request.
Walk through it step by step: Can't shift out of Park →

Common questions

What does P0931 mean?

The computer sees a signal or voltage in the shift lock solenoid circuit that is higher than it should be. The shift lock solenoid keeps the shifter locked in Park until you press the brake pedal.

Can I drive with code P0931?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0931?

Common possibilities to test include: open or broken wire in the shift lock solenoid circuit; bad brake light switch; failed shift lock solenoid; wire shorted to another power circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.