P0933 Hydraulic Pressure Sensor Circuit Range/Performance
What it means
The hydraulic pressure sensor is giving readings that don't match what the computer expects for the current conditions. The hydraulic pressure sensor monitors the pressure in the hydraulic unit that works the clutch and shifting on automated manual transmissions.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Compare the hydraulic pressure sensor reading with what it should be on a scan tool
- Inspect the wiring and connector for corrosion or damage
Signs you may notice
- Transmission warning or check engine light on
- Gears may be refused, slow or harsh to engage
- Transmission may go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing hydraulic pressure sensor
- CommonLow hydraulic fluid or weak hydraulic pump
- PossibleHigh resistance in the wiring or connector
- PossibleControl module software needs an update
Typical repair once the cause is confirmed
Correct any fluid or wiring problem first; if the readings are still wrong, replace the hydraulic pressure sensor.
Common questions
What does P0933 mean?
The hydraulic pressure sensor is giving readings that don't match what the computer expects for the current conditions. The hydraulic pressure sensor monitors the pressure in the hydraulic unit that works the clutch and shifting on automated manual transmissions.
Can I drive with code P0933?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0933?
Common possibilities to test include: failing hydraulic pressure sensor; low hydraulic fluid or weak hydraulic pump; high resistance in the wiring or connector; control module software needs an update. A shop should confirm the cause before replacing parts.