Home › Code lookup › P0935
Powertrain code · Transmission

P0935 Hydraulic Pressure Sensor Circuit High

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the hydraulic pressure sensor circuit that is higher than it should be. The hydraulic pressure sensor monitors the pressure in the hydraulic unit that works the clutch and shifting on automated manual transmissions.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the connector for pushed-out or loose pins
  2. Check the hydraulic pressure sensor circuit for an open wire or a short to voltage
  3. Test the hydraulic pressure sensor against the factory specification

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken wire in the hydraulic pressure sensor circuit
  • CommonFailed hydraulic pressure sensor
  • PossibleWire shorted to another power circuit
  • PossiblePoor ground or loose connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Repair the open or shorted wire or bad connector; if the wiring is good, replace the hydraulic pressure sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace hydraulic pressure sensor. Prepare an itemized shop request.

Common questions

What does P0935 mean?

The computer sees a signal or voltage in the hydraulic pressure sensor circuit that is higher than it should be. The hydraulic pressure sensor monitors the pressure in the hydraulic unit that works the clutch and shifting on automated manual transmissions.

Can I drive with code P0935?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0935?

Common possibilities to test include: open or broken wire in the hydraulic pressure sensor circuit; failed hydraulic pressure sensor; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.