Home › Code lookup › P0936
Powertrain code · Transmission

P0936 Hydraulic Pressure Sensor Circuit Intermittent

How urgent? Get it checked in the next few days

What it means

The signal from the hydraulic pressure sensor keeps dropping out or jumping around, which usually points to a loose connection or a damaged wire.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle-test the wiring and connector while watching live data
  2. Look for rubbed-through wiring near brackets and moving parts

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode
  • Problem may come and go, often over bumps

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose or corroded connector
  • CommonChafed wiring that opens or shorts as it moves
  • PossibleFailing hydraulic pressure sensor

Typical repair once the cause is confirmed

Repair the loose connection or damaged wire; replace the hydraulic pressure sensor only if it fails testing.

Repair costInsufficient verified pricing for this vehicle and repair
Replace hydraulic pressure sensor. Prepare an itemized shop request.

Common questions

What does P0936 mean?

The signal from the hydraulic pressure sensor keeps dropping out or jumping around, which usually points to a loose connection or a damaged wire.

Can I drive with code P0936?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0936?

Common possibilities to test include: loose or corroded connector; chafed wiring that opens or shorts as it moves; failing hydraulic pressure sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.