P0937 Hydraulic Oil Temperature Sensor Circuit
What it means
The computer found an electrical problem in the circuit for the hydraulic oil temperature sensor, which tells the computer how warm the fluid in the shift and clutch hydraulic unit is.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the wiring and connector at the hydraulic oil temperature sensor for damage, rubbing or corrosion
- Check related fuses, power and ground with a meter
- Test the hydraulic oil temperature sensor against the factory specification before replacing it
Signs you may notice
- Check engine or transmission light on
- Shifts may feel firmer or slower than normal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed hydraulic oil temperature sensor
- CommonBroken or damaged wiring to the hydraulic oil temperature sensor
- CommonLoose, corroded or water-damaged connector
- PossibleBlown fuse or missing power or ground
- PossibleFaulty transmission or engine computer (rare)
Typical repair once the cause is confirmed
Repair any wiring or connector fault found; if the circuit tests good, replace the hydraulic oil temperature sensor.
Common questions
What does P0937 mean?
The computer found an electrical problem in the circuit for the hydraulic oil temperature sensor, which tells the computer how warm the fluid in the shift and clutch hydraulic unit is.
Can I drive with code P0937?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0937?
Common possibilities to test include: failed hydraulic oil temperature sensor; broken or damaged wiring to the hydraulic oil temperature sensor; loose, corroded or water-damaged connector; blown fuse or missing power or ground. A shop should confirm the cause before replacing parts.