P0938 Hydraulic Oil Temperature Sensor Circuit Range/Performance
What it means
The hydraulic oil temperature sensor is giving readings that don't match what the computer expects for the current conditions. The hydraulic oil temperature sensor tells the computer how warm the fluid in the shift and clutch hydraulic unit is.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Compare the hydraulic oil temperature sensor reading with what it should be on a scan tool
- Inspect the wiring and connector for corrosion or damage
Signs you may notice
- Check engine or transmission light on
- Shifts may feel firmer or slower than normal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing hydraulic oil temperature sensor
- PossibleFluid actually running too hot or too cold
- PossibleHigh resistance in the wiring or connector
- PossibleControl module software needs an update
Typical repair once the cause is confirmed
Correct any fluid or wiring problem first; if the readings are still wrong, replace the hydraulic oil temperature sensor.
Common questions
What does P0938 mean?
The hydraulic oil temperature sensor is giving readings that don't match what the computer expects for the current conditions. The hydraulic oil temperature sensor tells the computer how warm the fluid in the shift and clutch hydraulic unit is.
Can I drive with code P0938?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0938?
Common possibilities to test include: failing hydraulic oil temperature sensor; fluid actually running too hot or too cold; high resistance in the wiring or connector; control module software needs an update. A shop should confirm the cause before replacing parts.