P0939 Hydraulic Oil Temperature Sensor Circuit Low
What it means
The computer sees a signal or voltage in the hydraulic oil temperature sensor circuit that is lower than it should be. The hydraulic oil temperature sensor tells the computer how warm the fluid in the shift and clutch hydraulic unit is.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the hydraulic oil temperature sensor wiring for chafed spots touching metal
- Check the circuit for a short to ground with a meter
- Unplug the hydraulic oil temperature sensor and see whether the reading changes
Signs you may notice
- Check engine or transmission light on
- Shifts may feel firmer or slower than normal
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWire shorted to ground in the hydraulic oil temperature sensor circuit
- CommonFailed hydraulic oil temperature sensor (internal short)
- PossibleCorroded or water-damaged connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Fix any shorted or damaged wiring; if the wiring is good, replace the hydraulic oil temperature sensor.
Common questions
What does P0939 mean?
The computer sees a signal or voltage in the hydraulic oil temperature sensor circuit that is lower than it should be. The hydraulic oil temperature sensor tells the computer how warm the fluid in the shift and clutch hydraulic unit is.
Can I drive with code P0939?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0939?
Common possibilities to test include: wire shorted to ground in the hydraulic oil temperature sensor circuit; failed hydraulic oil temperature sensor (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.