Home › Code lookup › P0940
Powertrain code · Transmission

P0940 Hydraulic Oil Temperature Sensor Circuit High

How urgent? Book a check when convenient

What it means

The computer sees a signal or voltage in the hydraulic oil temperature sensor circuit that is higher than it should be. The hydraulic oil temperature sensor tells the computer how warm the fluid in the shift and clutch hydraulic unit is.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the connector for pushed-out or loose pins
  2. Check the hydraulic oil temperature sensor circuit for an open wire or a short to voltage
  3. Test the hydraulic oil temperature sensor against the factory specification

Signs you may notice

  • Check engine or transmission light on
  • Shifts may feel firmer or slower than normal

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken wire in the hydraulic oil temperature sensor circuit
  • CommonFailed hydraulic oil temperature sensor
  • PossibleWire shorted to another power circuit
  • PossiblePoor ground or loose connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Repair the open or shorted wire or bad connector; if the wiring is good, replace the hydraulic oil temperature sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace hydraulic oil temperature sensor. Prepare an itemized shop request.

Common questions

What does P0940 mean?

The computer sees a signal or voltage in the hydraulic oil temperature sensor circuit that is higher than it should be. The hydraulic oil temperature sensor tells the computer how warm the fluid in the shift and clutch hydraulic unit is.

Can I drive with code P0940?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0940?

Common possibilities to test include: open or broken wire in the hydraulic oil temperature sensor circuit; failed hydraulic oil temperature sensor; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.