Home › Code lookup › P0942
Powertrain code · Transmission

P0942 Hydraulic Pressure Unit

How urgent? Get it checked in the next few days

What it means

The hydraulic unit that works the clutch and shifting on an automated manual transmission is not working as expected.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check hydraulic fluid level and look for leaks
  2. Watch hydraulic pressure on a scan tool while the pump runs

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow hydraulic fluid or a leak
  • CommonWeak or failed hydraulic pump
  • PossibleFaulty hydraulic pressure sensor
  • PossiblePump relay or wiring fault

Typical repair once the cause is confirmed

Fix any leak and refill; replace the pump or hydraulic unit if it cannot build pressure.

Common questions

What does P0942 mean?

The hydraulic unit that works the clutch and shifting on an automated manual transmission is not working as expected.

Can I drive with code P0942?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0942?

Common possibilities to test include: low hydraulic fluid or a leak; weak or failed hydraulic pump; faulty hydraulic pressure sensor; pump relay or wiring fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.