Home › Code lookup › P0945
Powertrain code · Transmission

P0945 Hydraulic Pump Relay Circuit/Open

How urgent? Get it checked in the next few days

What it means

The computer found an electrical problem in the circuit for the hydraulic pump relay, which switches on the electric pump that builds pressure for the clutch and shift hydraulics.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the wiring and connector at the hydraulic pump relay for damage, rubbing or corrosion
  2. Check related fuses, power and ground with a meter
  3. Test the hydraulic pump relay against the factory specification before replacing it

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed hydraulic pump relay
  • CommonBroken or damaged wiring to the hydraulic pump relay
  • CommonLoose, corroded or water-damaged connector
  • PossibleBlown fuse or missing power or ground
  • PossibleFaulty transmission or engine computer (rare)

Typical repair once the cause is confirmed

Repair any wiring or connector fault found; if the circuit tests good, replace the hydraulic pump relay.

Repair costInsufficient verified pricing for this vehicle and repair
Replace hydraulic pump relay. Prepare an itemized shop request.

Common questions

What does P0945 mean?

The computer found an electrical problem in the circuit for the hydraulic pump relay, which switches on the electric pump that builds pressure for the clutch and shift hydraulics.

Can I drive with code P0945?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0945?

Common possibilities to test include: failed hydraulic pump relay; broken or damaged wiring to the hydraulic pump relay; loose, corroded or water-damaged connector; blown fuse or missing power or ground. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.