Home › Code lookup › P0946
Powertrain code · Transmission

P0946 Hydraulic Pump Relay Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The hydraulic pump relay is giving readings that don't match what the computer expects for the current conditions. The hydraulic pump relay switches on the electric pump that builds pressure for the clutch and shift hydraulics.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Compare the hydraulic pump relay reading with what it should be on a scan tool
  2. Inspect the wiring and connector for corrosion or damage

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing hydraulic pump relay
  • PossibleHydraulic pump motor drawing too much current
  • PossibleHigh resistance in the wiring or connector
  • PossibleControl module software needs an update

Typical repair once the cause is confirmed

Correct any fluid or wiring problem first; if the readings are still wrong, replace the hydraulic pump relay.

Repair costInsufficient verified pricing for this vehicle and repair
Replace hydraulic pump relay. Prepare an itemized shop request.

Common questions

What does P0946 mean?

The hydraulic pump relay is giving readings that don't match what the computer expects for the current conditions. The hydraulic pump relay switches on the electric pump that builds pressure for the clutch and shift hydraulics.

Can I drive with code P0946?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0946?

Common possibilities to test include: failing hydraulic pump relay; hydraulic pump motor drawing too much current; high resistance in the wiring or connector; control module software needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.