Home › Code lookup › P0947
Powertrain code · Transmission

P0947 Hydraulic Pump Relay Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the hydraulic pump relay circuit that is lower than it should be. The hydraulic pump relay switches on the electric pump that builds pressure for the clutch and shift hydraulics.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the hydraulic pump relay wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the hydraulic pump relay and see whether the reading changes

Signs you may notice

  • Transmission warning or check engine light on
  • Gears may be refused, slow or harsh to engage
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWire shorted to ground in the hydraulic pump relay circuit
  • CommonFailed hydraulic pump relay (internal short)
  • PossibleCorroded or water-damaged connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the hydraulic pump relay.

Repair costInsufficient verified pricing for this vehicle and repair
Replace hydraulic pump relay. Prepare an itemized shop request.

Common questions

What does P0947 mean?

The computer sees a signal or voltage in the hydraulic pump relay circuit that is lower than it should be. The hydraulic pump relay switches on the electric pump that builds pressure for the clutch and shift hydraulics.

Can I drive with code P0947?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0947?

Common possibilities to test include: wire shorted to ground in the hydraulic pump relay circuit; failed hydraulic pump relay (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.