P0950 Auto Shift Manual Control Circuit
What it means
The computer found an electrical problem in the circuit for the manual shift control (tap-shift) circuit, which carries your up and down requests when you shift the automatic yourself.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the wiring and connector at the manual shift switch for damage, rubbing or corrosion
- Check related fuses, power and ground with a meter
- Test the manual shift switch against the factory specification before replacing it
Signs you may notice
- Manual or paddle shifting may not work
- Check engine light on
- Normal shifting in Drive usually still works
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed manual shift (tap-shift) switch
- CommonBroken or damaged wiring to the manual shift switch
- CommonLoose, corroded or water-damaged connector
- PossibleBlown fuse or missing power or ground
- PossibleFaulty transmission or engine computer (rare)
Typical repair once the cause is confirmed
Repair any wiring or connector fault found; if the circuit tests good, replace the manual shift switch.
Common questions
What does P0950 mean?
The computer found an electrical problem in the circuit for the manual shift control (tap-shift) circuit, which carries your up and down requests when you shift the automatic yourself.
Can I drive with code P0950?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0950?
Common possibilities to test include: failed manual shift (tap-shift) switch; broken or damaged wiring to the manual shift switch; loose, corroded or water-damaged connector; blown fuse or missing power or ground. A shop should confirm the cause before replacing parts.