Home › Code lookup › P0952
Powertrain code · Transmission

P0952 Auto Shift Manual Control Circuit Low

How urgent? Book a check when convenient

What it means

The computer sees a signal or voltage in the manual shift control (tap-shift) circuit circuit that is lower than it should be. The manual shift switch carries your up and down requests when you shift the automatic yourself.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the manual shift switch wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the manual shift switch and see whether the reading changes

Signs you may notice

  • Manual or paddle shifting may not work
  • Check engine light on
  • Normal shifting in Drive usually still works

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWire shorted to ground in the manual shift switch circuit
  • CommonFailed manual shift (tap-shift) switch (internal short)
  • PossibleCorroded or water-damaged connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the manual shift switch.

Repair costInsufficient verified pricing for this vehicle and repair
Replace manual shift switch. Prepare an itemized shop request.

Common questions

What does P0952 mean?

The computer sees a signal or voltage in the manual shift control (tap-shift) circuit circuit that is lower than it should be. The manual shift switch carries your up and down requests when you shift the automatic yourself.

Can I drive with code P0952?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0952?

Common possibilities to test include: wire shorted to ground in the manual shift switch circuit; failed manual shift (tap-shift) switch (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.