Home › Code lookup › P0953
Powertrain code · Transmission

P0953 Auto Shift Manual Control Circuit High

How urgent? Book a check when convenient

What it means

The computer sees a signal or voltage in the manual shift control (tap-shift) circuit circuit that is higher than it should be. The manual shift switch carries your up and down requests when you shift the automatic yourself.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the connector for pushed-out or loose pins
  2. Check the manual shift switch circuit for an open wire or a short to voltage
  3. Test the manual shift switch against the factory specification

Signs you may notice

  • Manual or paddle shifting may not work
  • Check engine light on
  • Normal shifting in Drive usually still works

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken wire in the manual shift switch circuit
  • CommonFailed manual shift (tap-shift) switch
  • PossibleWire shorted to another power circuit
  • PossiblePoor ground or loose connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Repair the open or shorted wire or bad connector; if the wiring is good, replace the manual shift switch.

Repair costInsufficient verified pricing for this vehicle and repair
Replace manual shift switch. Prepare an itemized shop request.

Common questions

What does P0953 mean?

The computer sees a signal or voltage in the manual shift control (tap-shift) circuit circuit that is higher than it should be. The manual shift switch carries your up and down requests when you shift the automatic yourself.

Can I drive with code P0953?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0953?

Common possibilities to test include: open or broken wire in the manual shift switch circuit; failed manual shift (tap-shift) switch; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.