P0958 Auto Shift Manual Mode Circuit High
What it means
The computer sees a signal or voltage in the manual mode switch circuit circuit that is higher than it should be. The manual mode switch tells the computer you have moved the shifter into manual (plus/minus) mode.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the manual mode switch circuit for an open wire or a short to voltage
- Test the manual mode switch against the factory specification
Signs you may notice
- Manual mode may not work or may switch on by itself
- Check engine light on
- Normal shifting in Drive usually still works
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the manual mode switch circuit
- CommonFailed manual mode switch
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the manual mode switch.
Common questions
What does P0958 mean?
The computer sees a signal or voltage in the manual mode switch circuit circuit that is higher than it should be. The manual mode switch tells the computer you have moved the shifter into manual (plus/minus) mode.
Can I drive with code P0958?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0958?
Common possibilities to test include: open or broken wire in the manual mode switch circuit; failed manual mode switch; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.